NEW
- USA Made -
Injection Pressure Regulator Valve
fits the following applications:
Ford 6.0L Diesel 2003 - 2010
2006 - 2010 4.5L LCF
International VT275, VT365, and MAXXFORCE 5 2005 - 2010
The IPR Valve is responsible for controlling the output pressure of the high pressure oil pump. Valve failure can cause a multitude of 6.0 Powerstroke IPR valve symptoms, including no-start conditions. If metal shavings are found on the inlet screen of the IPR high pressure oil pump failure may be imminent.
Excessive buildup of shavings on the IPR inlet screen will cause the screen to collapse which will allow particles into the 6.0 Powerstroke IPR valve causing it to jam.
6.0 Powerstroke Injection Pressure Regulator Valve replaces the following part numbers:
AP63417 1846057C1 5C3Z9C968CA 5C34-9C968-CA W3250216 HTV102
Injection Pressure Regulator Valve
Diagnostic Data and Installation Tools
Replacing a failed injection pressure regulator valve requires precise diagnostic data and the correct removal method. You can confirm a mechanical failure by checking your engine pressure parameters with a digital scan tool.
- Use a slotted socket to avoid crushing the plastic connector
- Inspect the pigtail wiring for heat damage and bare copper
- Verify the engine builds 500 PSI of high-pressure oil
- Install reliable diesel truck parts and accessories during reassembly
A stuck IPR valve prevents your engine from starting entirely. Addressing heat-damaged wiring and utilizing the correct removal socket prevents accidental damage to your new component.
Call the mechanics at Accurate Technical Services, LLC to verify fitment or discuss troubleshooting steps.
Frequently Asked Questions
- Do I need a special tool to remove this component?
Yes. You must use a specialized slotted socket. A standard wrench crushes the fragile electrical connector on top of the valve housing. The slotted tool slips securely over the wire connection and allows you to apply proper torque without removing the turbocharger.
- What scan tool numbers indicate a failure?
Your engine needs at least 500 PSI of high-pressure oil to fire the injectors. If the duty cycle reaches 84.9% while cranking, it means the computer is keeping the valve fully closed to build oil pressure.
- Why does my engine stall randomly when hot?
Extreme engine heat destroys the factory wiring pigtail. The plastic connector becomes weak and may come loose while driving down the road. This can expose copper wires, allowing them to touch the hot engine block and short out the electrical circuit.
- How can I prevent debris from jamming the new unit?
The factory mesh screen beneath the oil cooler tears under heavy fluid pressure. Once torn, unfiltered debris travels straight into the high-pressure oil pump. Upgrading to a heavy-duty stainless steel screen stops debris from reaching the high-pressure system and ruining your replacement parts.