6.2L and 6.5L Military HUMVEE
- Glow Plug Connector Set -

Made in the USA

The Problem:
For a long time we have been taking calls from customers asking if we had the glow plug harness ends for their HUMVEE Diesels. After being forced to say "No" many times, we finally decided to take the time to find an answer. The original glow plug connectors are now well over 20 years old, and most of them are in really sad condition. Unfortunately, the OEM connectors are long ago obsolete, as are the complete harnesses. Poor glow plug connections lead to low current flow, poor starts, and premature starter and battery deterioration.

What these ARE:
After spending more time than was justifiable calling connector companies and determining that no close facsimile of the original HUMVEE glow plug connector was to be found, we came up with the next best alternative. These are heavy duty, high quality "MADE IN THE USA" heat shrink bullet connectors. You will need to cut off your old terminals from the existing wires, remove a short strip of insulation, and crimp the new terminals onto your existing wiring. The upper section of the connector will then need to be heated to shrink it to the wiring. Each connector is internally coated with a glue like substance that melts when heated to create a moisture tight seal with the wire.

What these are NOT:
Please don't expect an exact duplicate of your original connectors. The OEM parts simply are not available anymore. These HUMVEE glow plug connectors do not have the positive snap retention system the original connectors did. However, they fit snugly and stay in place nicely.

What these will fit:
All 6.2L and 6.5L Military HUMVEE with the 24 Volt glow plug system and round glow plug connectors.

Fits Glow Plugs with the Following and other part numbers:

AC 15G, GM 5614017, AM General 5584164, TACOM 12338771, NSN 2920-01-188-3863

- Please note: Glow plug is not included - shown for illustration purposes only. This listing is for a set of (8) Glow plug connectors only. -